Iomega 3798300 Owner's Manual page 21

8
Connect an internal computer power supply
cable to your Zip
NOTE:
use the power Y-cable provided. Disconnect the power from the CD
drive or another device (do not disconnect the power to the hard drive)
and connect the power Y-cable. Connect the two extensions of the
power Y-cable to both the CD drive or other device and to the Zip
Internal drive.
Power Supply Cable
from Computer
CAUTION
the Zip ® drive.
9
Secure drive in drive bay.
Align the front of the Zip
If there is not a clear access to the drive bay mounting holes, refer to your
computer manual for additional instructions. Note that if the drive is held
in place securely by rails, you will not need to use the mounting screws.
Drive Bay
Mounting Screws
CAUTION
drive farther than 4.0 mm (about 0.16 inch). Mounting screws that are
too long could damage the drive.
® drive.
If the computer does not have a spare power supply cable,
Zip Internal
drive
Make sure the power supply cable is securely connected to
®
drive with other drives installed in the computer.
Mounting screws must not extend into the Zip
®
® Internal
21