Saw Chain Filing And File Gauges - Jonsered CS 2171 WH Operator's Manual

Recommended original and replacement bar and chain combinations
These Husqvarna chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting equipment.
Bar
Length, inch Pitch, inch
16 3/8
18 3/8
20 3/8
24 3/8
28 3/8
Note: For the chains above you are free to choose between 0,050" and 0,058" gauge drive link for the corresponding
bar, see the table below.
0,050"/1,3 mm H46
0,058"/1,5 mm H42
WARNING! This chain saw model is capable of severe kickback that could result in serious
!
injuries to the user. Do not operate this saw unless you have extraordinary cutting needs and
experience and specialized training for dealing with kickback. Saws with significantly reduced
kickback potential are available. Always use the safest saw and cutting equipment applicable to
your cutting need.
Saw chain filing and file gauges
TECHNICAL DATA
Gauge, inch Max. nose radius
1,5 11T
1,5 11T
1,5 11T
1,5 11T
1,5 11T
H47
H48
Chain
Type Drive link count
Jonsered H42 60
Jonsered H42 68
Jonsered H42 72
Jonsered H42 84
Jonsered H42 92
English – 39