Saw Chain Filing And File Gauges - Jonsered CS 2172 WH Operator's Manual

Recommended cutting equipment for USA
These Jonsered chain saw models are in the ANSI category of saws above 3,8 cu. in. and are not required to comply
with low kickback performance requirements. However, for these models we recommend the following cutting equipment.
Recommended cutting equipment for Canada
The following cutting attachments are approved for the models Jonsered CS 2166, CS 2172 and CS 2172WH. The
combinations of powerhead, bar and chain meet all requirements outlined in the CSA Z62.1-11 Chainsaws and Z62.3-
11 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the
corresponding maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list.
For guide bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of
sprocket teeth may be considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent
or less kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which
are available at your dealer.
Length, inch Pitch, inch
16
18
20 3/8
24
28
Note: For the chains above you are free to choose between 0.050" and 0.058" gauge drive link for the corresponding
bar, see the table below.
0.050"/1,3 mm
0.058"/1,5 mm
WARNING! This chain saw model is capable of severe kickback that could result in serious
!
injuries to the user. Do not operate this saw unless you have extraordinary cutting needs and
experience and specialized training for dealing with kickback. Saws with significantly reduced
kickback potential are available. Always use the safest saw and cutting equipment applicable to
your cutting need.
Saw chain filing and file gauges
1153687-49 Rev.2 2015-09-02
TECHNICAL DATA
Guide bar
Gauge, inch
0,058
H46
H42
Max. nose radius Type
11T Jonsered H42
Saw chain
Drive link count
60
68
72
84
92
English – 39