Table of Contents
Advertisement
Changing the unit's settings
∫ Manual Tuning
You can set each channel manually.
Digital TV Manual Tuning
Physical Channel
[
Signal Quality
0
Signal Strength
0
No.
Channel Name
Digital TV:0
Select physical channel
Start tuning
Select offset
RETURN
1 Select the channel.
2 Adjust the frequency.
≥Adjust the frequency by checking the signal strength
and signal quality displays.
3 Press [OK] to start scan.
The set channel is displayed in the table.
∫ Update Channel List
You can update channels to the latest one.
≥This takes about 3 minutes.
Digital TV Update Channel List
Scan
CH 6
This will take about 3 minutes.
RF Ch
Channel Name
Digital TV:0
Searching
RETURN
"Finished" is displayed when the search is finished.
Press [RETURN
].
∫ Child Lock ( Parental Rating )
You can restrict the viewing and recording of channels
unsuitable to children.
Set a ratings level to limit broadcast viewing and playback.
≥Follow the on-screen instructions.
≥PIN is required to change. (
80
VQT3C14
]
MHz
10
10
Type
New
69
Type
Quality
78)
∫ Signal Condition
You can check the quality and strength of signals.
Press [CH W X] to select the channel.
Signal Quality
Signal Strength
0
2
4
6
Network Name
RF Parameter
[
]
MHz
Good
Channel Up
Poor
RETURN
Channel Down
Bad
Signal Quality
Red bar
The signal quality is bad.
Yellow bar
The signal quality is poor.
Green bar
The signal quality is good.
Signal Strength
0
Signal strength is 0%.
10
Signal strength is 100%.
≥When the signal is too strong (red bar), reduce the signal
amplification at your aerial.
∫ New Channel Message
Set whether to obtain the information automatically when a
new digital channel is added.
≥ After performing "Update Channel List" or "Manual Tuning" if the channel
number has already been assigned, channel number for the newly tuned
channel will be assigned from 800ch onward.
8
10
Advertisement
Table of Contents
