Table of Contents
Advertisement
Basic Configuration
Note: If you have previously paired to the Bluetooth serial adapter(s), make sure to follow
the unpairing procedure on page 29 before attempting to connect to a new device.
Method 1 – Auto-paring
Follow steps below
1
Set device mode
Set one serial adapter to Master (switch 4 = ON), and the other to Slave (switch 4 = OFF)
2
Set baud rate
Set matching baud rates as needed
3
Power ON
Power On both serial adapters and wait approximately fifteen (15) seconds
·Blue LED on slave adapter will slowly blink (once every 2-3 seconds)
·Blue LED on master adapter will rapidly blink
4
Pair and Connect
Wait approximately two (2) minutes for the serial adapters to automatically pair and connect
18
14
Advertisement
Table of Contents
