IOGear GBU521 Quick Start Manual
Bluetooth 4.0 usb micro adapter
Hide thumbs
Also See for GBU521:
- Quick start manual (1 page) ,
- Installation manual (68 pages) ,
- Quick start manual (2 pages)
Table of Contents
Advertisement
Quick Links
Download this manual
See also:
Installation Manual
Advertisement
Table of Contents
Related Manuals for IOGear GBU521
Summary of Contents for IOGear GBU521
- Page 1 Quick Start Guide Bluetooth 4.0 USB Micro Adapter GBU521 PART NO. Q1235-d www.iogear.com...
- Page 2 Compliance Information Limited Warranty Contact ©2018 IOGEAR. All Rights Reserved. Part No. Q1235-d, the IOGEAR logo is trademarks of IOGEAR. Microsoft and Windows are registered trademarks of Microsoft Corporation. IOGEAR makes no warranty of any kind with regards to the information presented in this document. All information furnished here is for informational purposes only and is subject to change without notice.
-
Page 3: Package Contents
Package Contents Installation-Windows 1 x Bluetooth 4.0 USB Micro Adapter 1. Make sure that the IOGEAR Bluetooth adapter is NOT ® 1 x Quick Start Guide plugged into the computer before installing the software. 1 x Warranty Card - Insert the CD or download the software driver from the IOGEAR website. - Page 4 3. Please allow the preparation to load until 100% 5. When you encounter the message of “No Bluetooth device was detected” please go ahead and plug the GBU521 into your USB port on the computer to continue. 4. Select Agree and Install Bluetooth Software if you are OK with default installation folder location on your computer.
- Page 5 7. Once the installation reaches 100%, click Finish to complete 9. Click on the up arrow on the lower right side of your the installation. application tray and click on the Bluetooth icon. 8. Once the installation is completed with software driver and the 10.
- Page 6 11. Turn on the Bluetooth device that you would like to be 12. At this point, the installation of the new Bluetooth is now discovered and connected and select the Bluetooth device completed. Click on the upper arrow on the lower right you wish to connect and click “next”.
-
Page 7: Compliance Information
Operation is subject to the following two conditions: Make sure you: (1) this device may not cause interference, 1. Visit www.iogear.com for more product information 2. Visit www.iogear.com/support for live help and (2) this device must accept any interference, including interference that may cause undesired operation of the device. - Page 9 ©2018 IOGEAR ®...