T-Bar And Take Keys - Datavideo SE-900 Instruction Manual

T-Bar and Take Keys

The T-Bar and the Take Keys enable you to manually or automatically perform transitions.
The T-Bar is manual way to perform a transition.
The T-Bar travels from top to bottom, or bottom to top. The active transition will be performed at the same
speed as the movement of the T-Bar. You can move the T-Bar as fast, or as slow as you like.
If the T-Bar is left midway between top and bottom the transition will pause at that point. For example if the
active transition is a side wipe, and the T-Bar is stopped in the middle, then you will see Channel A on one
half of the screen, and Channel B on the other.
T-Bar Fully Up
N.B. The keys on the Main and Sub Source Rails will be inactive while the T-Bar is active. Only when
the T-Bar is fully up or fully down will the keys respond.
The GPI TAKE Key will perform automatic takes based on the 10 Preset Effects. The first
press of the GPI Take key will activate Preset Effect F1, the next F2 and so on.
Once Preset Effect F10 has been performed the cycle will restart at F1 and continue to cycle
through again.
To program Preset Effects please see Storing and Recalling Presets
The CUT Key performs a simple switch from main source to sub source. It will always switch,
irrespective of the active transition.
The TAKE Key performs the active transition at the active preset speed.
Each time you press the TAKE Key the active transition will be performed between the Main
Source and the Sub Source.
The active transition is indicated in the transition area, and in the Status Display.
The Preset Speed is indicated in the Level /Speed area, and also in the Status Display
T-Bar at a midway point T-Bar Fully Down
46