Table of Contents
Advertisement
12
TB LED — Turbo LED Connector
Attach a 2-pin turbo LED cable to it. The LED lights when the system is
in turbo mode. Manufacture default has set the board in turbo mode due
to most of hardware and software are compliance to turbo mode.
FAN (JP10) — CPU Cooling Fan Connector
This 3-pins connector provides 12V power for the CPU cooling fan
which matches the pin assignment of this connector. If you enable the
Suspend Mode function in BIOS setup, this fan will stop when the
system is into the suspend mode.
Note: Make sure the pin assignment of our CPU Cooling Fan is matched
with this connector before connecting it, otherwise, you may
damage either the mainboard or the cooling fan.
JP9 – Wake-On-LAN (WOL) Header
Attach a 3-pin connector from the LAN card which supports the Wake-
On-LAN (WOL) function.
connected computer through the LAN card. (The cable should be
included with the LAN card.)
CPU Cooling Fan
Connector
(Pin Assignment)
1
GND
2
12V
3
SENSOR
This function lets users wake up the
JP9 Pin Assignment
Hardware Setup
Advertisement
Table of Contents
