Speaker Ð Speaker Connector; Reset Ð Hardware Reset Control; Ide1/Ide2 Ð On-Board Primary/Secondary Ide Hdd; Connectors - SOYO 6KF User's Manual & Technical Reference

11
Hardware Setup
SPEAKER – Speaker Connector
Attach the system speaker to connector SPK.
RESET – Hardware Reset Control
Attach the Reset switch to RESET. Closing the Reset switch restarts the
system.
IDE1/IDE2 – On-board Primary/Secondary IDE HDD

Connectors

Attach on-board hard disk drives to these connectors.

COM1/COM2 Connectors

Connect COM1/COM2 devices to these connectors.
HDD LED – IDE HDD LED Connectors
Attach on-board IDE device LEDs to this connector. The LED lights
when an IDE device is active.

FDC Connector

Attach floppy cable to this connector.
PRT – Parallel Port Connector
Attach parallel port cable to this connector.
USB (J3) – (Universal Serial Bus) Connector
Attach USB cable to these connectors for external USB device. Please
ask your dealer for the cable.
PW/SW – ATX Power Supply On/Off Switch Connector

(Momentary Type)

Attach a two-pin switch to this connector for turning the ATX power
supply on/off. DonÕt forget to remove all jumper caps on JP12 to enable
the ATX power supply function.