Advertisement
If you have a 54" mower deck skip to step #9.
For smaller decks use the following instructions.
STep 4: (See fIGure 4)
•
Remove the mower stop bracket and its two bolts and
nuts from the R.H. side of the tractor frame.
•
If the tractor has a muffler guard at the front of the
R.H. foot rest, remove the bottom bolt and nut, and
the washer which is located between the guard and
the tractor frame.
•
Remove the two bolts from the bottom of both the
R.H. and L.H. foot rests.
MUFFLER GUARD
(only on models
with side muffler)
REMOVE BOLTS, NUTS
& WASHERS SHOWN
FIGURE 4
STep 5: (See fIGure 5)
•
Assemble the R.H. hanger bracket to the bottom hole
where the mower stop bracket was removed and to
the upper hole under the front of the foot rest. Fasten
with two 3/8" x 1" hex bolts, 3/8" lock washers and
3/8" nylock nuts. (On tractors with muffler guards,
slide the hanger bracket between the guard and the
tractor frame.)
3/8" NYLOCK
3/8" LOCK
NUT
WASHER
FIGURE 5
Call 1-866-576-8388 for missing parts or assembly help
DO NOT RETURN TO STORE
REMOVE
BRACKET
RIGHT SIDE VIEW
R.H. HANGER
BRACKET
3/8" x 1"
HEX BOLT
RIGHT SIDE VIEW
STep 6: (See fIGure 6)
•
Assemble the L.H. hanger bracket to the left side of
the tractor frame using two 3/8" x 1" hex bolts, two
3/8" lock washers and two 3/8" nylock nuts.
3/8" LOCK
L.H. HANGER
WASHER
BRACKET
3/8" x 1"
HEX BOLT
FIGURE 6
STep 7: (See fIGure 7)
•
Assemble a frame bracket to the L.H. foot rest and
sway bar bracket. Use two 3/8" x 1-1/4" hex bolts, two
3/8" lock washers and one spacer.
•
Assemble a shoulder bolt (P) and a 3/8" flanged nut
(BB) (both supplied with the snow thrower) to the
frame bracket.
3/8" x 1-1/4"
HEX BOLT
3/8" LOCK
WASHER
SPACER
3/8" FLANGED NUT (BB)
(snow thrower)
FIGURE 7
3/8" NYLOCK
NUT
LEFT SIDE VIEW
FRAME
BRACKET
SHOULDER
BOLT (P)
(snow thrower)
SWAY BAR
BRACKET
LEFT SIDE VIEW
3
Advertisement
