Installing and Removing Intel
Installing Intel
1. Squeeze the sides of the filler panel to disengage it from the server system back panel and
remove it (see letter A).
2. Position the module over the server board, fit the front of the module into the back panel slot
(see letter B).
3. Attach the module to the server board connector (see letter C).
4. Secure the module with the three screws as shown (see letter D).
Removing Intel
1. Remove the three screws as shown (see letter A).
2. Remove the module out of the server system (see letter B).
3. Install the I/O expansion module filler panel into the system back panel.
®
Intel
Server System R1000SP Service Guide
®
I/O Expansion Module
Figure 56. Installing Intel
®
I/O Expansion Module
Figure 57. Removing an I/O Expansion Module
Hardware Installations and Upgrades
®
I/O Expansion Module
®
I/O Expansion Module
33