Panasonic AW-HS50N Operating Instructions Manual page 33

4. Specifications
Control I/O
Other
Ambient operating
temperature
Humidity
Power requirements
Current consumption
Dimensions
(W  H  D)
Mass
 Supplied AC adapter 
Rated input: AC 100 V to 240 V, 1.3 A, 47 Hz to 63 Hz
Rated output: DC 12 V, 3.5 A, 42 W
The provided power cable is for 125 V AC or less.
Use it within AC 100 V to 120 V.
 The AC adapter and power cable provided must be used without fail.
Mass and dimensions shown are approximate.
Specifications are subject to change without notice.
LAN (RJ-45)
10BASE-T/100BASE-TX
(For IP control)
TALLY/GPI
(D-sub 15-pin, female,
inch thread)
SERVICE switch [SV/NM] (for maintenance purposes)
Normally, this switch is used as the "NM" position.
0 °C to 40 °C (32 °F to 104 °F)
10 % to 90 % (no condensation)
DC 12 V 10 % (AC adapter provided)
2.0 A (DC 12 V)
210  67  177 mm (8-1/4˝  2-5/8˝  6-15/16˝)
[excluding protrusions]
1.4 kg (3.08 lbs.)
Connecting cable:
LAN cable (category 5 or above),
max. 100 m [328 ft.], STP (Shielded Twisted Pair)
cable recommended
  When connecting to a hub (switching hub), use a
straight cable.
Use a crossover cable when connecting the unit
and another device on a 1:1 basis without going
through a hub.
INPUT : 5 inputs, photocoupler sensing
OUTPUT : 7 outputs, open collector output
(negative logic)
33