Panasonic AW-HS50 Manual

Combining PinP (Picture in Picture)
★ This is to explain the procedure for combining a sub screen image with the background image.
Background
(Procedure for selecting the PinP signal)
① Press PinP button – (Fig.1-A) to set the crosspoint buttons to PinP material selection mode (PinP button blinks).
② Using the B bus buttons, select the PinP signal. – (Fig.1-B)
③ Press PinP button to release the PinP material selection mode(PinP button goes off).
④ Press PinP ON button – (Fig.1-E) to combine the PinP image.
（A）
（B）
(PinP settings)
Changing the shape, position and size of the PinP image to be combined is enabled as well as adding the border effect to
it.
⑤ Hold down the OSD ON button – (Fig.1-C) for 2 seconds to open the menu. (To close it, hold down the button again
for 2 seconds.)
⑥ Use the OSD/TIME dial – (Fig.1-D) to set or adjust the settings for the menu items in [3] PinP Menu. – (Fig.2 & Fig.3)
PinP Signal
＋
(Figure 1: AW-HS50 Control Panel)
(Figure 2: AW-HS50 Menu Display Screen)
Output Image
＝
（D）
（C）
（E）