How To Set Remote Control Selector Switch - Toshiba RAS-24NKHD-E5 Service Manual

8-6. How to Set Remote Control Selector
Switch
When two indoor units as installed in seperated rooms,
there is no need to change the selector switch.
<Remote control selector switch>
• When two indoor units are installed in the same
room or the adjacent two rooms, they may be
controlled simultaneously with a single remote
control. To prevent this, set either unit and its
remote control to B setting. (Both units are set to A
setting before shipment.)
• The remote control signal is not recived when the
indoor unit setting is different from the remote
control one.
1. Set the remote control selector switch with the
indoor unit.
1) Turn the circuit breaker of the main power switch off
before setting the selector switch.
2) Remove the Air inlet grille and Front panel. (Refer to
Chapter 10-1, procedure 1 )
3) Open the Electrical part cover (Refer to chapter
10-1, procedure 2 ), then cut the jumper (J01)
with only the nippers.
CAUTION
Do not use any other sharp tools (such as cutters,
pliers, or the like), Such tools may cause
breakage or damage.
See Fig. 8-6-1
Fig. 8-6-1
2. Set the remote control selector switch with the
remote control
[B] is indicated on the liquid crystal display when
setting remote control from A to B. [A] is
not indicated on the display even if the selector
is set to A.
1) Load the remote control with the batteries.
2) Press the [CHECK] button using something with
sharp point. (The preset temperature on the remote
control changes to [00].)
3) Press the [MODE] button while pressing the
[CHECK] button, [B] is indicted at the right of the
present temperature display.
• To reset the switch to the [A] setting, press the
[MODE] button again while pressing the [CHECK]
button.
PAP
MODE
HiPOWER
SWING
CLR
CLOCK
RESET
3. Confirm that the indoor unit can operate with
the new setting.
– 42 –
FILE NO. SVM-06010
AUTO
TEMP
PRESET
[MODE] button
ECO MEMO
1 . 3 . 5 . 9H
FIX FAN SLEEP
SET
ON OFF
FILTER
CHECK
[CHECK] button
Fig. 8-6-2
A
B