Sanyo PLV-55WHD1 Service Manual page 35

22-
1 Joint Board unit and Lamp ballast connector removal.
1. Remove the Screw-A(T3x10) and remove the Joint Board unit.
2. Remove the 2 Screws-B(M3x8) and remove the Lamp Ballast connector.
22-
2 Joint Board unit disassemblies.
1. Remove the Screw-A(M3x6) and remove the Joint Board.
2. Remove the 2 Screws-B(M3x6) and remove the Thermal Switch(SW902).
A
Joint Board unit
A
B
B
Joint Board
Lamp Ballast connector
Thermal Switch(SW902)
B
B
- 35 -
Mechanical disassemblies
Fig. 22-1
Fig. 22-2