Sanyo PLV-55WHD1 Service Manual page 13

Lamp Replace Counter
Be sure to reset the lamp counter after the lamp is
replaced. When the lamp counter is reset, the LAMP
REPLACE indicator will be turned off.
1 Press the MENU key to display the Main menu.
Use the CURSOR ed keys to highlight (green)
2
Lamp Counter Reset. Press ENTER.
Use the CURSOR d key to select Yes. Press
3
ENTER.
Press the EXIT key to return to normal TV viewing.
4
NOTE:
● Do not reset Lamp replace counter without implementation of
lamp replacement. Be sure to reset the Lamp replace count-
er only after replacing the lamp.
● The lamp counter cannot be reset even if you press the
RESET key on the remote control.
●
How to check Lamp Used Time
The LAMP REPLACE indicator will light yellow when
the total lamp used time reaches 7,980 hours -(✽).
This is to indicate that lamp replacement is required.
The total lamp used time is calculated by using the
below expression;
Total lamp used time = T
T : used time in LAMP MODE "Low"
eco
T : used time in LAMP MODE "High" & "Mid"
normal
You can check the lamp replace counter following to
below procedure.
1
Press and hold INFO button on the remote control
and then press CH(+) button on the side control.
2
The LCD Projection TV used time and lamp used
time will be displayed on the screen briefly.
+ Tnormal x 1.14 -(✽)
eco
Use this feature only after replacing the lamp in your PTV.
LCD Projection TV used time
C o u n t e r
T o t a l T i m e
N o r m a l
E c o
k A + B
(✽) The specifications are subject to change without
notice.
- 13 -
Lamp Replacement
Lamp counter reset?
0 0 2 2 3 H
A 0 0 1 0 0 H
B 0 0 1 2 3 H
0 0 2 3 7 H
Total lamp used time