Invacare Nutron Series Operating & Maintenance Manual page 57

Invacare power wheelchair owner's operator and maintenance manual
Table of Contents

Advertisement

2. Install battery clamp covers onto battery cables (FIGURE 12.8) ‐
A. RED battery clamp cover onto RED battery cable.
B. BLACK battery clamp cover onto BLACK battery cable.
NOTE: Only one (1) battery cable and battery clamp cover are shown for clarity. Both battery 
clamp covers install in the same manner.
Battery Clamp
Cover
When connecting the battery cable/ring terminal(s) to the battery(ies) clamp(s),
the battery cable(s) MUST be connected in the position shown in Detail "A" of
FIGURE 12.9. Otherwise, damage can occur to the battery cable and/or battery
clamp covers.
3. Connect battery cable(s) to battery(ies) terminal(s)/post(s) as shown in Detail "A" of 
FIGURE 12.9:
A. NEGATIVE (‐) BLACK battery cable/ring terminal between the mounting plate 
and battery clamp of NEGATIVE (‐) battery terminal/post.
B. POSITIVE (+) RED battery cable/ring terminal between the mounting plate and 
battery clamp of POSITIVE (+) battery terminal/post.
4. Secure the battery cable(s)/ring terminal(s) to the battery clamp(s), BLACK to 
NEGATIVE (‐) and RED to POSITIVE (+), with existing hex screws as shown in Detail 
"A" of FIGURE 12.9. Securely tighten. 
5. Verify battery cable ring terminal(s) are correctly installed and securely tightened. 
6. Slide battery clamp covers down battery cables and onto battery terminals as shown 
in Detail "B" of FIGURE 12.9.
7. Using 11½‐inch long tie‐wraps, secure each terminal cap in place as shown in Detail 
"B" of FIGURE 12.9.
NOTE: It will be necessary to trim excess tie‐wrap in order to install the battery box top(s).
8. Install the battery box top(s).
9. Install the battery box(es) into the wheelchair. Refer to Installing/Removing the 
Battery Boxes on page 49.
NOTE: New battery(ies) MUST be fully charged BEFORE using, otherwise the life of the 
battery(ies) will be reduced.
10. If necessary, charge the battery(ies). Refer to Charging Batteries on page 61.
Part No.1106644
FIGURE 12.8 Installing Battery Clamp Cover
CAUTION
Battery Cable
57
SECTION 12—BATTERIES
Nutron® Series

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Nutron r32Nutron r32lx

Table of Contents