Setup - Life Fitness 5500HR Assembly Instructions Manual

1.2 S
ETUP
Read the Operation Manual before setting up the Life Fitness
Cross-Trainer.
1.2.1 W P
HERE TO LACE THE
Following all Safety Instructions, position the Cross-Trainer where it
will be used. When correctly positioned, the Cross-Trainer can be
easily mounted from the side and the six foot power adapter cord
can be plugged into the back of the Cross-Trainer without binding
or being routed across a walkway. Allow 1 foot of clearance in front
of the Cross-Trainer to allow for movement of the pedal lever.
1.2.2 H T S
OW O TABILIZE THE
T
RAINER
After placing the Cross-Trainer where it will be used, check its
stability. If there is a rocking motion, even if slight, the unit needs to
be stabilized. To level it, check the stabilizing feet on the stabilizing
bars to determine which one does not rest fully on the floor. Using a
finger, rotate this stabilizing to lower it. Recheck the stability and
adjust again as needed until the Cross-Trainer is stable and no
longer rocks. The adjustment may be locked into position by
tightening the jam nut against the stabilizer bar with an open end
9/16 inch wrench.
6
C -T
ROSS RAINER
L F C -
IFE ITNESS ROSS
1.2.3 P I C -T
LUG N THE ROSS
The Life Fitness Cross-Trainer comes with a standard power supply
for the U.S., or a universal power supply that will accept country-
specific line cords.
Insert the power adapter jack into the barrel plug on the back of the
Cross-Trainer. Then insert the transformer into the wall outlet (or
the universal power supply if outside the U.S.). Make sure the cord
is routed so that it doesn't bind and will not be walked on.
Check that the console LEDs light up. If not, recheck the plug and
wall connections or make sure the wall outlet has power.
Pla ne36
RAINER