Interface / Terminal Id Table; Data Format Editor Commands; Send Commands - Honeywell Hyperion 1300g User Manual

Interface / Terminal ID Table

Terminal
USB
Serial
Keyboard

Data Format Editor Commands

When working with the Data Format Editor, a virtual cursor is moved along your
input data string. The following commands are used to both move this cursor to
different positions, and to select, replace, and insert data into the final output.
For examples that use the Data Format Editor commands, refer to
Editor Commands

Send Commands

Send all characters
F1 Include in the output message all of the characters from the input
message, starting from current cursor position, followed by an insert
character. Syntax = F1xx where xx stands for the insert character's hex
value for the CP1252 character. Refer to the
(Code Page 1252),
character codes.
Send a number of characters
F2 Include in the output message a number of characters followed by an
insert character. Start from the current cursor position and continue for
"nn" characters or through the last character in the input message,
followed by character "xx." Syntax = F2nnxx where nn stands for the
numeric value (00-99) for the number of characters, and xx stands for
the the insert character's hex value for the CP1252 character. Refer to
the ASCII Conversion Chart (Code Page 1252),
2 for decimal, hex and character codes.
5 - 4
Model(s)
PC keyboard (HID)
Mac Keyboard
PC Keyboard (Japanese)
Serial (COM driver required)
HID POS
USB SurePOS Handheld
USB SurePOS Tabletop
RS232 TTL
RS232 True
RS485 (IBM-HHBCR 1+2, 46xx)
PS2 compatibles
AT compatibles
on page 5-4.
beginning on page A-2 for decimal, hex and
Terminal ID
124
125
134
130
131
128
129
000
000
051
003
002
Data Format
ASCII Conversion Chart
beginning on page A-