Operation Switches When Embroidery Unit Is Attached; Thread Tension Control - Singer XL-420 Instruction Manual

OPERATION SWITCHES WHEN
EMBROIDERY UNIT IS ATTACHED
OPERATION SWITCHES
START/STOP BUTTON
When start/stop button is pushed, machines starts slowly. To
stop the machine, push the button again and the machine will
stop sewing and the needle stops at its highest position.
FORWARD STITCH BUTTON
After the embroidery design has been transferred to the
machine, the embroidery can be advanced one stitch at a
time. Note: The embroidery hoop will move as it is advancing
through the design.
To advance continuously, press and hold this button.
REVERSE STITCH BUTTON
press the Reverse Stitch button. Pressing the button once will
reverse one stitch at a time. To reverse continuously, press
LED INDICATOR
Green light indicates machine is ready to start.
Red light indicates machine is operating.
Flashing red light indicates a problem or an error.
* Flashing for 2 - 3 seconds shows that an incorrect
operation was made.
* C o n t i n u o u s f l a s h i n g i n d i c a t e s t h a t t h e m a c h i n e
malfunctions.

THREAD TENSION CONTROL

Set it at "E" for embroidery to loosen thread tension.
of fabric and thread being used.
NOTE: When sewing designs created by the software for
Photo Stitch (optional) it is recommended to decrease
the thread tension toward "0" and activate the "Speed
sending the design to the machine. This ensures the best
performance of the machine.
76
LED indicator
Témoin a diode
Indicador LED
Forward stitch button
Interupteur couture avancé
Interruptor de puntadas
hacia adelante
Reverse stitch button
Interrupteur couture arrière
Interruptor de puntadas
hacia atrás
Start/stop button
(For embroidery only)
Interrupteur marche/arrêt
(Pour la broderie seulement)
Botón de comienzo/parada
(Sólo para bordado)