Assembly And Adjustments - Shindaiwa T2500 Owner's/Operator's Manual

Assembly and Adjustments

Handle
Barrier
Handle
Bar
Handle
Handle Positioning Label
Outer
Tube
4 Socket-head
Capscrews
4 Socket-head
Capscrews
Figure 5
Figure 5A
Assembly and Adjustments
Adjust Throttle Lever Free Play
The throttle lever free play should be
approxiamtely 3/16-1/4 inch(4-6 mm).
See Figure 6. Make sure that the throttle
lever operates smoothly without binding.
If it becomes necessary to adjust the
lever freeplay, follow the procedures
and illustrations that follow.
Figure 7 XST019A
1. Loosen the air cleaner cover knob
and remove the air cleaner cover.
See Figure 7.
3/16-1/4 inch (4-6 mm)
2. Loosen the lock nut on the cable
Figure 6 Throttle Freeplay
adjuster. See Figure 8.
6
Handle.
1. The handle is attached to the outer
tube at the factory and positioned
vertically. See Figure 5.
2. Loosen the 4 socket-head capscrews
on the handle and
rotate the handle 90 degrees.
See Figure 5A.
3. Position the handle forward of the
Handle Positioning Label at the best
position for operator comfort (usually
Outer Tube
about 10 inches ahead of the throttle
housing).
Barrier
4. Secure the handle by alternately
Bar
tightening the four socket-head cap
screws in a diagonal or
"criss-cross" fashion.
3. Turn the cable adjuster in or out as
required to obtain proper free play
3/16-1/4 inch(4-6 mm). See Figure 8.
4. Tighten the locknut.
Lock
Nut
Cable
Adjuster
Figure 8
5. Reinstall the air cleaner cover.