Vivotek IP3111 User Manual page 75

modem connection or 6 minutes by modem, but still subject to user's network.
5. After upload is complete, close the connection.
6. If the received FLASH.BIN is checked without error, Network Camera will update the
software in Flash memory and restart automatically. When Network Camera starts writing
firmware, both status LED indicators will stay on until system restarts. It takes about 30 to
40 seconds. User should keep the power stable during the update process. After the system
restarts, Network Camera may need installation depending on whether the "Reset network
at next boot" option is enabled or not. After Network Camera boots up, reload the web page
in the browser.
If power fails during the software upgrade, the program in the memory of Network
Camera may be destroyed permanently. If Network Camera cannot restart properly, ask
the dealer for technical service.
74
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532