Royal RG1000 Owner's Manual page 23

RG-DIGITAL CONTROL TROUBLESHOOTING
Always disconnect the grill from AC power before accessing the control for service
Warning
or working under the grill.
Removing the control from the grill, installing the control into the grill, or working under the grill while
the grill is connected to AC power could result in shock or could damage the control.
Digital Control Display is Blank
cook control switch is set to the off position. Set cook control switch to the smoke position or any temperature setting.
Circuit breaker on AC outlet is tripped. Reset wall power outlet circuit breaker.
Control is disconnected from grill AC power. Verify control wiring harness plug with black wire is connected to AC
power.
Digital Control Display is Blank
Control AC line fuse is blown. Replace control's fuse F1 with provided spare fuse or a replacement fuse.
A blown AC line fuse may be caused by several conditions including shorted
grill component lead wires, a jammed auger, or a failing igniter. Inspect the
grill's components and component lead wires if replacement fuses are
continually blown.
Grill Will Not Ignite
No fuel in fi repot. Fill hopper with good, dry fuel. Verify auger is properly
connected to control. Clear auger if jammed. Replace auger and/or auger
motor if defective.
No draft air fl ow
Verify draft fan is properly connected to control and
operating normally. Replace draft fan if defective.
No ignition heat source
Verify igniter is properly connected to control and operating
normally.
Replace igniter if defective
Control is defective
Contact Royall Grills technical support.
F u s e