Royal RG1000 Owner's Manual page 11

- CHECK to make sure pellets are dry and being delivered to the
burn pot
o If pellets are not being delivered, make sure hopper is full
and auger is not jammed (is turning)
DANGER:
- CHECK to see if hot rod glows red after a couple minutes
o If hot rod does not glow. Unplug grill, and check fuse on
back of control board. NOTE: a spare is wire tied to the
functioning fuse at the connection point
o If fuse is ok and rod does not get hot, a new HOT ROD will
be needed. Manual lighting of pellets can be done at
owner's discretion.
GRILL FIRE GOES OUT:
- CHECK that supply of pellets has not been interrupted.
- CHECK that pellets are dry and designed for grilling applications
- CHECK that excessive wind is not affecting burning.
- CHECK Visually verify that auger is turning properly
o Auger not turning: check that cotter pin holding shaft to
motor is not broke.
o Set to high mode and visually recheck that auger is not
turning. If not, unplug grill and check motor connector
plug to see that it is properly connected (connector with
RED wire). If connections are tight, a new auger drive
motor will be needed.
o Check fan to see if it's spinning. If not, unplug grill and
check fan connector with ORANGE wire to ensure that it
has not come loose. If connection is tight, turn power back
on and check fan. NOT turning, indicates a new fan motor
will be needed.
DO NOT STICK FINGERS INTO MOVING AUGER