Table of Contents
Advertisement
• When the memory is
full, you will hear a
beep and "
Memory
" appears. You
Full
cannot store names
and numbers.
• The pause key counts
as one digit. Pressing
redial/p more than
once increases the
length of pause
between numbers.
• If you select a Speed
dial location where a
number is already
stored, the new number
will replace the old
number, and the old
number will be stored as
a phonebook location.
[ 24 ]
P H O N E B O O K
2) Press select/ch, "
Store/Edit Name
3) Store the name (up to 16 characters) by using the number keypad.
• See the "Steps for entering names and special characters" (see page 27).
• Use call id/
and
/RocketDial/
• Use xfer/del to delete characters as needed.
• Press and hold xfer/del to delete all the characters.
If a name is not required, go to step 4.
4) Press select/ch to store the name,
"
" appears.
Store/Edit No.
5) Press the number keypad to enter the phone number (up to 20 digits),
press select/ch to store the number.
6) "
" appears. Press + or - to move the pointer
Distinctive Ring
to one of the Distinctive Ring options, then press select/ch.
If you choose not to store a "
" option.
Selectn
7) "
" appears. Press + or - to move the pointer to select
Speed Dial
the Speed dial location (10 locations: SPD1-SPD0).
If you choose not to store the name/number as a Speed Dial, simply
select the "
" option.
No Selectn
8) Press select/ch. You will hear a confirmation tone and
"
" appears on the display.
Done!
" appears.
to move the cursor to the desired location.
", simply select the "
Distinctive Ring
No
Advertisement
Table of Contents
