MHSC MJ27NR Installation And Operating Instructions Manual page 18

FIREPLACE PREPARATION
ASSEMBLY PROCEDURE:
1. Center the gas log unit on the fireplace or firebox. Make certain the front of the burner sits
inside the front edge of the fireplace or firebox.
2. Anchor holes are located on the right and left sides of the unit. After centering the burner cor-
rectly, mark the hole positions on the fireplace/firebox floor. Drill two (2) 5/32" diameter holes
1
approximately 1 /
3. Anchor the burner to the fireplace/firebox floor using the screws provided. Figure 13
Proper installation of the heater is essential to prevent any movement of the gas logs and
controls during operation.
18
" deep.
2
Screw
FP2006
Figure 13 - Secure Heater to Floor of Fireplace/Firebox
secure to floor
Anchor Hole
Screw
FP2006
86D0024