Setting The Rf Output Power Level; Setting The Attenuation Level Of The Audio Input - Sony UWP-V1 Operating Instructions Manual

next time you turn on the transmitter
by setting the POWER switch to ON.
Notes
• When you are setting the transmission
channel, the transmitter cannot be used to
transmit signals.
• Do not remove the batteries while setting
the transmission channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
"Setting the transmission channel" from
step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the transmitter and then
immediately turn it on right after setting
the transmission channel, the unit may
not operate normally. Wait a few seconds
before turning it on again.
Setting the RF output
power level
The procedure below can be
performed with the body-pack
transmitter (UTX-B2) and the hand-
held microphone (UTX-H2).
For U30/U42/CE33/CE38/CE42/CE57/
CE62/CE67/AU66 models:
The RF power output level can be set at 30
mW ("H") or 5 mW ("L").
For E model:
The RF power output level can be set at 10
mW ("H") or 2 mW ("L").
You can select the RF output power level
from "H" or "L" in setting mode.
RF output level to
operation of multiple channels, and set
it to for long-distance operation.
"H"
40 Transmitter Settings
Set the
for simultaneous
"L"
1
Turn on the transmitter while pressing
down the SET button.
2
Press the SET button repeatedly until
the RF output level indication appears
in the display section.
3
Press the + button to select "H," or
press the – button to select "L."
4
Set the POWER switch to OFF to
complete the setting, or press the SET
button to set other items.
The results are stored in memory.
The change becomes effective the next
time you turn on the transmitter by
setting the POWER switch to ON.
Setting the attenuation
level of the audio input
The procedure below is the same
for all UWP series transmitters
(UTX-B2/H2/P1).
The attenuation level can be set during
signal transmission.
Note
When the MIC/LINE input selector of the
UTX-B2 or the INPUT selector of the
UTX-P1 is set to LINE position, attenuation
level of the audio input is always 0 dB and
cannot be reset. In this case, adjust the
output level on the audio source device.
1
Do the following while there is
no signal transmission.
Turn on the transmitter while pressing
down the SET button, and press the