Searching The Available Channels Within The Group (Clear Channel Scan) - Sony UWP-V1 Operating Instructions Manual

Example: When the channel group 00 is
selected
6
When the desired channel number
appears, leave the tuner for about 10
seconds or press down the SET button
for more than one second.
The selected channel number stops
flashing and the selection is stored in
memory.
To select the channel by
frequency indication
1
Press the SET button for more than one
second.
Keep pressing the SET button until the
display section parameters start to
flash.
2
Press the SET button repeatedly until
the frequency indication appears and
starts flashing.
3
Press the + or – button to select the
frequency.
36 Tuner Settings
4
When the desired frequency appears,
leave the tuner for about 10 seconds or
press down the SET button for more
than one second.
The selected channel number stops
flashing and the selection is stored in
memory.
Notes
• Even when you are setting the reception
channel, the tuner can be used to receive
signals.
• Do not remove the batteries while setting
the reception channel. If they are
inadvertently removed, re-insert them
immediately and redo the procedure
"Setting the reception channel" from
step 1.
• Make sure that the selected channel is the
same on the transmitter and tuner being
used in the same system.
• If you turn off the tuner and then
immediately turn it on right after setting
the reception channel, the unit may not
operate normally. Wait a few seconds
before turning it on again.
Searching the available
channels within the group
(Clear Channel Scan)
The procedure below can be
performed with the portable
diversity tuner (URX-P2) only.
Available channels within the specified
channel group can be searched.
Before performing this procedure, select
the channel group.
For details on channel group selection, see "Setting
the reception channel" on page 35.
1
While pressing down the SET button,
press the + button.