Table of Contents
Advertisement
For details, see "Using a USB Keyboard" on
page 18.
Selecting the Frequency
Band
(BAND)
Match the frequency range on this
microphone to that of the Sony digital
wireless receiver.
See "Carrier Frequencies and Channel
Steps" on page 32 for differences in
frequency ranges that can be set for optional
receivers combined with this transmitter.
For details about the frequency range of each band,
refer to "Sony Digital Wireless Microphone System
Frequency Lists" on the supplied CD-ROM.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Notes
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
power on. Then change the setting after
the signal transmission has stopped.
• Be sure to select the group/channel right
after selecting the frequency band. To
start signal transmission with the selected
frequency band/group/channel, turn off
the power and then turn it on again.
Selecting the Group/
Channel
(GP/CH)
See "Carrier Frequencies and Channel
Steps" on page 32 for factory settings.
For details, see "Selecting the Group/Channel" on
page 13.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Setting the RF Output
Power
(RF POWER)
You can set the RF output power.
1 mW (LOW): transmitted by 1 mW
10 mW (MID): transmitted by 10 mW
50 mW (HIGH): transmitted by 50 mW
Notes
• The setting for this function cannot be
changed during actual signal
transmission. To change the setting, turn
off the microphone first. Then, while
holding down the SET button, turn the
power on. And then, change the setting
after the signal transmission has stopped.
• To start signal transmission with the
selected RF output power setting, turn off
the power and then turn it on again.
Using wireless remote control, this function
can be controlled from the receiver and
other devices.
For details on wireless remote control function, see
"Using the Cross Remote" on page 14.
Setting the Audio Input
Level
(INPUT LEVEL)
You can set the input level to the analog
head amp.
Press the + or – button repeatedly to select
the appropriate attenuation level.
The reference levels for the various settings
are as follows:
Setting Menus
21
Advertisement
Table of Contents
