Hdmi Status Mode - Integra DSR-4.8 Instruction Manual

Troubleshooting—Continued

HDMI Status Mode

If you're using an HDMI connection and there's no picture or sound, you can check the status of the HDMI connection
by pressing and holding down the DVD receiver's [Display] button for 10 seconds until a message ID appears on the
display. Look up the message ID in the following tables and check the HDMI connections and settings on both the DVD
receiver and the connected component.
HDMI connection and HDMI-related settings status
Displayed ID
Turn the DVD receiver and the connected component off, then turn them on again. Make sure that
MSG ID 001
the connected component is working properly and that the DVD receiver's HDMI settings are con-
MSG ID 015
figured suitably for that component.
MSG ID 021 Input is selected other than DVD or VIDEO1. No output from HDMI OUT.
When the DVD or VIDEO1 input is selected, the "HDMI Output Setting" is set to "Off". Change it to
MSG ID 022
"On" (page 30).
MSG ID 023 Check the settings and connections of the TV and component connected to DVD receiver.
No picture from the HDMI connection
Displayed ID
MSG ID 002 The "HDMI Output Setting" is set to "Off". Change it to "On" (page 30).
MSG ID 003 The HDMI cable may not be connected properly. Check the connection. Also, make sure the HDMI
MSG ID 004 input on the TV is correctly configured to received HDMI.
Make sure the HDMI input on the TV is correctly configured to received HDMI.
The connected component may not support HDCP. Make sure the connected component supports
MSG ID 005 HDCP.
MSG ID 006 Turn the DVD receiver and the connected component off, then turn them on again.
MSG ID 007 The DVD receiver may be connected to the other component's DVI jack. Some TVs may not prop-
erly receive the video output by the DVD receiver. Also, with a DVI connection, there will be no
sound.
The DVD receiver's "HD Resolution" setting is set to "720p" or "1080i". If your TV doesn't support
MSG ID 008
these resolutions, select another resolution (page 30).
The connected component may not be receiving the HDMI signal properly.
MSG ID 009
Try selecting another resolution on the DVD receiver (page 30).
No sound from the HDMI connection
Displayed ID
MSG ID 011 The connected component may not support 96 kHz PCM. Set the DVD receiver's "Linear PCM
MSG ID 014 Out" setting to "Down Sample On" (page 61).
MSG ID 012 The connected component may not support Dolby Digital. Set the DVD receiver's "Digital/HDMI
MSG ID 013 Audio Out" setting to "PCM" (page 61).
MSG ID 016 The connected component may not support DTS. Set the DVD receiver's "Digital/HDMI Audio Out"
MSG ID 017 setting to "PCM" (page 61).
MSG ID 020 Audio from SACDs is not output by the HDMI OUT.
Message
Message
Message
73