Integra DSR-4.8 Instruction Manual page 42

Using the Listening Modes—Continued
T-D (Theater-Dimensional) Listening Angle
Setting
With this setting, you can specify the angle of the front
left and right speakers relative to the listening position.
Processing for the Theater-Dimensional listening mode
is based on this setting. Ideally, the front left and right
speakers should be equidistant from the listening posi-
tion and at an angle close to one of the three available
settings.
Front left speaker
1 Press and hold the [Setup] but-
ton for 3 seconds.
Remote controller
When selecting the input other than
DVD, just press the [Setup] button.
"Balance" appears on the display.
HOLD
Listening Mode and Receiver Settings
Depending on the listening mode, the setup menu settings may be enabled/disabled as shown below.
Settings
Speaker Output Balance
Subwoofer Level
Correcting Sound and Picture
Sync
Crossover Frequency
Enabling/Disabling the Subwoofer
Front Speakers Size
*1 During playback a DVD-Audio or SACD, this setting is fixed at 100 Hz.
*2 During playback a DVD-Audio or SACD, this setting is fixed at Small.
42
Front right speaker
20/30/40°
Page #
55
32
55
56
55
55
2
Use the Up and Down [
buttons to select "Angle", and
use the Left and Right [
buttons to select: "Narrow",
"Middle", or "Wide".
Narrow: Select if the listening angle
Middle: Select if the listening angle
Wide: Select if the listening angle
3 When you've finished, press the
[Setup] button again.
The setup menu closes.
Note:
Only when the T-D listening mode is selected, this set-
ting is available.
Listening Mode
Direct Stereo

✔

✔

✔

✔

✔

✔
]/[
is 20 degrees.
is 30 degrees (default).
is 40 degrees.
✔: available
T-D
✔
✔
✔
✔
*1
✔
*2 ✔
]
]/ [ ]