Table of Contents
Advertisement
CHAPTER 2. BASIC OPERATION OF MASTER STATION
Step 5. Press the new keys to register using the dialing keys [0] – [9] or function keys [ ], [#] or [REDIAL].
Notes
• If the [C] key is pressed before dialing a complete number, the contents before the [C] key was
pressed are all erased.
• Mark "-" is displayed when the [REDIAL] key is pressed.
• The display shown below is an example of entering the functional number of paging.
Step 6. Press the [PTT] key after completing the entry of the registration number.
Registration is then completed, as indicated by a confirmation tone.
Step 7. Shift the [REGISTER] switch back to the OFF position. The station will be placed in standby mode.
2.8.3. Auto dialing key registration erasure
Step 1. Set the [REGISTER] switch on the master station's top panel to the ON position. The display panel
will be placed in registration mode.
Step 2. Press the [PTT] key.
The following characters will be displayed.
Step 3. Press the registered auto dialing key to delete. The selected key number (example: [2]) will be
displayed together with the registered number.
Step 4. Press the [PTT] key.
The registered number displayed after the auto dialing key [2] will be erased.
2-10
DISTRIBUTED BY: www.leedan.com info@leedan.com Toll-Free: 800-231-1414
2 : 1 2 3 4 5 6
2 : 8 0 #
2 : 1 2 3 4 5 6
1 1 : 5 9 am
Re g – m ode
Au t o d i a l
2 : 1 2 3 4 5 6
2 :
Example of "123456" being entered
Example showing the registration completion of "123456"
Example showing "123456" has been registered
Example of auto dialing key [2]
Advertisement
Table of Contents
