Table of Contents
Advertisement
Insignia NS-LCD37HD-09 37" LCD TV
Connecting the power cord
To connect the power cord:
•
Plug the power cord into the AC IN jack on
the back of your TV, then plug the other end
into a power outlet.
Using your TV
Turning your TV on or off
To turn your TV on or off (standby mode):
1 Plug the power cord into a power outlet.
2 Press
(power). Your TV turns on.
3 Press
again to turn off your TV. When you
turn off your TV, it goes into standby mode.
Warning
When your TV is in standby mode, it is still
receiving power. To completely disconnect power,
unplug the power cord.
Note
If your TV does not receive an input signal for
several minutes, it automatically goes into standby
mode.
Using the remote control
•
Point the remote control toward the remote
control sensor on the front of your TV.
•
Make sure that no objects are between the
remote control and the remote control
sensor.
•
Do not expose the remote control to shock.
•
Do not expose the remote control to liquids or
high humidity.
•
Do not place your TV in a location where
sunlight or bright light shines on the remote
control sensor. This can interfere with the
signal from the remote control.
The following illustration shows the best angle
for using the remote control.
16.4" (5 m)
www.insignia-products.com
Selecting the video input source
To select the video input source:
1 Turn on your TV, then press INPUT. The
INPUT SOURCE menu opens.
2 Press
or
to select the video source, then
press ENTER. You can select:
•
TV
•
AV1
•
AV2
•
S-Video1
•
S-Video2
•
Component1
•
Component2
•
HDMI1
•
HDMI2
•
HDMI3
•
VGA
You can also select the input source using the
following remote control buttons:
•
COMP—Press once to select Component1.
Press twice to select Component2.
•
HDMI–Press once to select HDMI1. Press
twice to select HDMI2. Press three times for
HDMI3.
•
VIDEO—Press once to select AV1. Press
twice to select AV2. Press three times for
S-Video1. Press four times for S-Video2.
•
TV—Press to select TV.
Selecting the TV signal source
The first time you turn on your TV, you must
select the TV signal source. Your TV stores this
information.
You do not need to change the TV signal source
unless it changes. For example, you change
from an outside antenna to cable TV.
To select the TV signal source:
1 Press MENU. The on-screen menu opens.
Picture
Picture Mode
Contrast
Brightness
Color
Tint
Sharpness
Color Mode
Select
Time
Setup
Lock
Channel
Standard
50
50
50
0
50
Cool
Move
Exit
MENU
11
Hide quick links:
Advertisement
Table of Contents
