Connecting The Antenna; Connecting A Vcr - Insignia NS-LCD22 User Manual

NS-LCD22.fm Page 6 Monday, February 19, 2007 1:39 PM
3 Replace the cover.
Caution
Improper use of batteries can result in a leakage
of chemicals and/or explosion. Be sure to follow
the instructions below.
• Place batteries with their terminals
corresponding to the (+) and (-) indications.
• Different types of batteries have different
characteristics. Do not mix batteries of different
types.
• Do not mix old and new batteries. Mixing old
and new batteries can shorten the life of new
batteries and/or cause old batteries to leak
chemicals.
• Remove batteries as soon as they are
non-operable. Chemicals that leak from
batteries can cause a rash. If chemical leakage
is found, wipe with a cloth.
• The batteries supplied with the remote may
have a shorter life expectancy due to storage
conditions.
• If the remote control is not used for an
extended period of time, remove the batteries
from the remote control.
Before connecting devices
• Carefully check the terminals for position and
type before making any connections.
• The illustration of the external equipment
may be different depending on your model.
• Loose connectors can result in image or color
problems. Make sure that all connectors are
securely inserted into their terminals.
• Refer to the user manual of the external
device as well.
• When connecting an external device, turn the
power off on the panel to avoid any issues.
Locating the television
Install the television in a room where direct light
will not fall upon the screen. Total darkness or a
reflection on the picture screen may cause
eyestrain. Soft and indirect lighting is
recommended for comfortable viewing.
6

Connecting the antenna

Optimum reception of color requires a good
signal and generally means that an outdoor
antenna must be used. The exact type and
position of the antenna depends upon your
particular area.
Wall antenna
socket
Note
• We recommend that the 75-ohm coaxial cable
be used to eliminate interference and noise
which may occur due to radio wave conditions.
• Do not bundle the antenna cable with the
power cord.
• If you cannot install the antenna correctly,
contact your dealer for assistance.

Connecting a VCR

VCR
Connect the Audio/Video cables between the
Audio (L/R)/Video jacks on the television and
VCR.
Note
Cables are often color-coded to connectors.
Connect red to red, white to white, and yellow to
yellow.
Note
• For better video, you can use the S-video
terminal if your source supports it.
• The S-video terminal shares the same audio
jacks with VIDEO and has priority over the
VIDEO jack. To use a device connected to the
video jack, disconnect any plug from the
S-video terminal.
To play the VCR:
1 Turn on your television, then press the INPUT
button. The SOURCE INPUT menu opens.
2 Press
S-Video if the S-VIDEO terminal is used),
then press ENTER to confirm.
3 Turn on your VCR, insert a videotape, then
press the Play button.
www.insignia-products.com
Insignia NS-LCD22 LCD TV
TV Rear
Bronze
wire
RF Coaxial Cable
(75 ohm)
Antenna input
AV cable
S-Video cable
TV Rear
or to select Composite (or