Turning On Your Tv For The First Time; Understanding The Basics; Turning Your Tv On Or Off; Selecting The Video Input Source - Insignia NS-L32Q09-10A User Manual

Turning on your TV for the
first time
The first time you turn on your TV, the Setup Wizard
opens. The Setup Wizard guides you through
setting up basic settings including the menu
language, TV signal source, and the channel list.
To set up your TV:
1 Make sure that you have:
• Installed the remote control batteries. (See
page 7 for details).
• Connected an antenna, cable TV, or satellite
TV. (See pages 9, through page 10 for details.)
• Connected the power cord. (See page 9 for
details.)
2 Press (power) to turn on your TV. The Choose
your menu Language screen opens.
OK
MOVE
ENTER
Set menu language to English, Français,Español
3 Press or to highlight English, Français, or
Español, then press OK/ENTER to confirm your
selection. The Choose your TV source screen
opens.
Antenna
Cable
Cable/Satellite box
Scan for channels
OK
MOVE
ENTER
Select Antenna If using an antenna for standard or HD TV
4 Press or to highlight Antenna, Cable, or
Cable/Satellite box (if your cable TV uses a box,
select Cable/Satellite box), then press
OK/ENTER. If you chose Antenna or Cable, your
TV automatically starts scanning for channels
available in your viewing area. If you chose
Cable/Satellite box, your TV does not need to
scan for channels.
When the scan is complete, the Setup Wizard
closes automatically.
Note
You can change the menu language or scan for
channels at a later date. For more information, see
"Selecting the menu language" on page 29 or
"Automatically scanning for channels" on page 19.
Choose your menu Language
English
Français
Español
SELECT PREVIOUS
MENU EXIT
Choose your TV source
0 Analog Channels
0 Digital Channels
SELECT PREVIOUS EXIT
MENU EXIT
www.insigniaproducts.com

Understanding the basics

Note

Turning your TV on or off

To turn your TV on and off:
1 Make sure that the power cord is connected to
your TV and a power outlet.
2 Press
indicator LED turns blue.
3 Press
TV enters Standby mode and the power
indicator LED turns red.
Warning
Note

Selecting the video input source

To select the video input source:
1 With your TV turned on, press INPUT. The Source
EXIT
List opens.
2 Press
your want. You can select:
• TV
• AV 1
• AV 2
• Component 1
• Component 2
• VGA
• HDMI 1
• HDMI 2
• HDMI 3
• HDMI 4
3 Press OK/ENTER.
Unless otherwise noted, all tasks in this section are
based on using the remote control.
(power) to turn on your TV. The power
(power) again to turn off your TV. Your
When your TV is off, power still flows into it. To
disconnect power, unplug the power cord.
If your TV does not detect a signal and you do not
press any button for 15 minutes, your TV goes into
Standby mode automatically.
Source List
TV
AV 1
AV 2
Component 1
Component 2
VGA
HDMI 1
HDMI 2
HDMI 3
HDMI 4
or to highlight the video input source
15