When replacing any part on this appliance, use only spare parts that you can be assured conform to the safety and performance specification that we require. Do not use reconditioned or copy parts that have not been clearly authorised by Ideal.
• This appliance must not be operated without the casing correctly fitted and forming an adequate seal. 30, 40, 60, 80, 100, 120, & 150 30P, 40P, 60P & 80P • If the boiler is installed in a compartment then the compartment MUST NOT be used for storage purposes.
Page 3
bOIlER CONTROlS / dISPlAy Standby mode Standby Mode If the boiler has been switched to Standby Mode the following screen will be displayed For Central Heating No Boiler operation will take place with this setting. See Frame 38 to change to Summer or Winter select Winter Mode setting For Hot Water...
Page 4
Press SELECT and a screen similar to the following will be displayed The kW output number in the 1st line will vary depending the Ideal Evomax 80kW maximum output of the boiler Ideal Evomax 80kW normal operation Set Flow Temp’...
To shut Down the Boiler Condensate Drain 1. for short periods The condensate drain must not be modified or blocked. Set the external controls to OFF. Wait 4 minutes and then Blockage of the condensate drain, caused by debris or freezing, isolate the mains supply to the boiler.
Page 6
Kingston upon Hull, HU5 4JN. in the design and performance Telephone: 01482 492 251 Fax: of its products. The right is 01482 448 858. Registration No. therefore reserved to vary London 322 137. specification without notice. Ideal Consumer Helpline Tel: 01482 498 376 www.idealheating.com...