Konica Minolta MAXXUM FLASH 5600HS (D) Instruction Manual page 56

CONNECTING CAMERA AND FLASH BY CABLE
Equalizing The Power Level Of All Flash Units
All the flash units in A and B group can be used.
1. Connect the flash units with off-camera cables.
2. Switch all flash units on.
3. Take the photo.
Flash-Ratio Control (varying the intensity of individual flash)
Set up the A group flash with ratio control. The following applies
when the 5600HS (D) is used. See each flash manual for other
flashes.
56
When using two or more flash units, it
is possible to provide a flash intensity
of 1 and 2 (or 2 and 1) respectively.
• Ratio control is not possible with B
group flash units only (p. 55).
• Ratio control cannot be used with
300si, as proper exposure may not be
obtained.
+ button
– button
Select button
Mode button