Wireless Flash Range - Konica Minolta MAXXUM FLASH 5600HS (D) Instruction Manual

WIRELESS/REMOTE FLASH MODE
Usable cameras and flash units:
• Maxxum/Dynax 9, 7, 800si, 700si, or 600si.
• A Wireless Remote Flash Contoroller and one or more 5600HS (D),
3600HS (D), 5400HS, 5400xi, or 3500xi.

Wireless Flash Range

The wireless flash uses a light signal from the built-in flash as a trig-
ger to operate the off-camera flash unit. Follow the points below
when positioning the camera, flash, and subject.
• Photograph in dark locations indoors.
• If you rotate the flashtube using bounce-flash function (p. 28) so that
wireless/remote control-signal receiver points toward the camera, it
will be easier for the flash to receive a signal from the camera.
• Install the off-camera flash within the gray area in the following dia-
gram. See the camera's manual if you are using a DiMAGE digital
camera. See the flash unit manual for details of the distance between
the flash and the subject (Table 2) for all except the 5600HS (D).
42
[3] Using the Wireless Remote
Flash Controller (p. 52).
The following two modes are avail-
able.
• Use off-camera flash units (photo
p. 40).
• Use two off-camera flash units to pro-
vide a light intensity ratio of 1:2 or 2:1.
,