King Canada KC-10TC Instruction Manual page 8

ASSEMBLING BELT AND PULLEY COVER
1. Assemble the V-belt to the motor and arbor pulleys. Using a straight
edge, align the two pulleys as shown in Fig.15. If necessary move the
motor and/or motor pulley for proper alignment.
2. Place spacer (A), washer (B) and wing nut (C) on screw as shown in
Fig.16.
3. Assemble the belt cover (A) to the bracket and fasten in place using the
wing nut (B) and washer (C) as shown in Fig.17.
ASSEMBLING BLADE GUARD AND SPLITTER ASSEMBLY
IMPORTANT: Make sure the motor power cord is NOT connected to the
power source when assembling blade guard assembly.
1. Assemble support rod (C) to the hole in the saw trunnion Fig.18.
2. Assemble splitter mounting bracket (B) to the support rod (C) using hex.
bolts (D) and lockwashers as shown in fig.18.
3. Assemble blade guard and splitter assembly (A) to the bracket (B) and
fasten in place with the two hex. bolts (E) as shown in Fig.18. Using a
straight edge, align the splitter (A) to the saw blade. If necessary the
splitter mounting bracket (B) can be moved. It is very important that the
splitter be aligned with the saw blade in order to prevent kickbacks.
3. IMPORTANT: For safety reasons and to prevent binding, when
assembling the blade guard and splitter assembly, make sure the
supporting arm and the two guards are level with the table.
INSTALLING SWITCH
The switch must be installed to the left table extension wing, Fig. 19. The
switch plate must be placed underneath the table extension.IMPORTANT:
The bolts must be inserted and screwed from the rear, you must install the
switch in this manner to be able to slide a rip fence without interference on
the left side of the blade.
A
E
B
C
D
FIGURE 18
ASSEMBLY
C
FIGURE 15
A
B
FIGURE 16
B
C
A
FIGURE 17
FIGURE 19