LIMITED TOOL WARRANTY King Canada makes every effort to ensure that this product meets high quality and durability standards. King Canada warrants to the original retail consumer a 2-year limited warranty as of the date the product was purchased at retail and that each product is free from defects in materials.
Page 3
GENERAL & SPECIFIC SAFETY RULES 1. KNOW YOUR TOOL 10. USE RIGHT TOOL. Read and understand the owners manual and labels affixed to the Don’t force the tool or the attachment to do a job for which it was tool. Learn its application and limitations as well as its specific not designed.
FIGURE 2 electrical circuit box, the wire size must be increased proportionately in order to deliver ample voltage to the motor. Refer to Fig. 2 for extension cord length and size (gauge). MOTOR KC-1401FX WIRING DIAGRAM SWITCH MOTOR LEAD WHITE...
ASSEMBLY CAUTION: Follow all the assembly & installation instructions completely before connecting the Wood Bandsaw to a power source. STAND ASSEMBLY NOTE: It is easier not to tighten the stand bolts until the belts and pulleys are installed and aligned. Finger tighten only. This allows easy adjustment later. 1.
Page 6
ASSEMBLY INSTALLING THE PULLEY GUARD Place the pulley guard (A) Fig.7 over the pulleys and fix it to the stand top using small pan hd screws, washers and hex. nuts. FIGURE 7 INSTALLING UPPER & LOWER GUIDE BLOCK ASSEMBLIES 1. LOWER GUIDE. Locate the protective plate (A) Fig.8 and the lower guide block assembly (B), install them to the frame as shown using two small hex.
ASSEMBLY INSTALLING THE TABLE 1. Locate the trunnion bracket (A) Fig.10 and bolt it securely to the bandsaw as shown using two hex. bolts and spring washers (B). Then install the 90 table stop bolt (C), thread a hex. nut onto the bolt and turn the bolt into the threaded hole in the left, rear of the trunnion bracket.
ADJUSTMENTS & OPERATION ADJUSTING THE BLADE TENSION To tighten the blade, turn the blade tensioning knob (A) Fig.14 clockwise. There is a tension scale guide on the block (B) that shows how tight the blade should be, depending on the blade width. A rule of thumb, the blade should deflect 1” when pushed with moderate pressure at the midpoint of the wheels.
OPERATION, MAINTENANCE & TROUBLESHOOTING POWER CORD AND TURNING WOOD BANDSAW ON/OFF Once all assembly and adjustments steps have been done, this Wood Bandsaw is now ready to be used. Connect the motor (A) Fig.17 and switch (B) quick connect cables and then connect the power cord to power source. Make sure the power source matches the specifications indicated on the machine nameplate.