Assembly - King Canada KC-10TC Instruction Manual

TOOLS PROVIDED FOR ASSEMBLY
1. Arbor-blade guard bracket wrench.
2. 12mm combination wrench.
3. Two allen wrenches.
ADDITIONAL TOOLS REQUIRED
1. Large flat-head screwdriver.
2. Phillips #1 point screwdriver
Note: The use of sockets with a ratchet will lessen the assembly time
required.
ASSEMBLING STAND
Assemble the top brace (B) and the tie bar (C) to the leg (A) of the stand, as
shown in Fig.1, using the carriage bolts, flat washers, lockwashers and nuts.
Fasten the rest in the same manner.
SUGGESTION: Do not tighten nuts until all hardware is in place. Then place
stand on a flat surface and square up the braces and tie bars, etc. before
final tightening of carriage bolts, washers, lockwashers and nuts.
Four rubber feet are supplied with the stand and should be assembled to the
stand. Note: It is necessary to seat the truss head screw in the recess of the
foot. Fig.2 illustrates the stand assembled.
ASSEMBLING SAW TO STAND
Line up the holes in the bottom ledge of the saw cabinet with the four holes
(A) Fig.2, on the top shelf of the stand. The front of the saw should be at the
end of the stand indicated as (B) in Fig.2. Fasten the saw to the stand using
the four hex. bolts, flat washers, lockwashers and nuts supplied with the
stand.
FASTENING SAW TO A WOOD STAND OR BENCH
If the saw is to be used without the stand that is supplied with it, we suggest
that the saw always be fastened to a supporting surface using the holes on
the bottom ledge of the saw cabinet. Fig.3 illustrates the size and center to
center distance of the mounting holes in the saw cabinet. CARE MUST BE
TAKEN THAT A HOLE IS PROVIDED IN THE WOOD STAND OR BENCH
TO FACILITATE THE REMOVAL OF SAW DUST.
FASTENING STAND OR BENCH TO FLOOR
IF DURING OPERATION THERE IS ANY TENDENCY FOR THE TOOL TO
TIP OVER, SLIDE OR WALK ON SUPPORTING SURFACE, THE STAND
OR BENCH MUST BE SECURED TO THE FLOOR.
ASSEMBLING RAISING AND TILTING HANDWHEELS AND LOCK KNOBS
Assemble the raising and the tilting handwheels (A) and lock knobs (B) to
the raising and tilting screws, as shown in Fig.4. Make sure the slot in the
handwheels engage with the roll pins in the raising and tilting screws.

ASSEMBLY

A
FIGURE 1
B
FIGURE 2
FIGURE 3
B
FIGURE 4
A
A
B