King Canada KC-10TC Instruction Manual page 6

ASSEMBLING GUIDE RAILS
1. Assemble the front and rear guide rails to the table using the special
screws (A) and spacers (B), as shown in Fig.5. The guide rail with the
calibrations goes on the front of the table and these calibrations are to be
on the top side.
2. The guide rails can also be positioned to the left of the saw blade,
providing 24'' rip capacity to the right or left of the blade. When the guide
rails are used on the left of the saw blade, calibrations will be on the
bottom of the rail and consequently cannot be used.
ASSEMBLING EXTENSION WINGS
Assemble the table extension wings to your saw as follows:
Fasten extension wings to the table using the six cap screws and lock
washers supplied. Use a straight edge to level the extension wings to the
table surface as shown in Fig.6. Also make sure the extension wings are
flush with the front edge of the table.
NOTE: The saw must be bolted to the supporting surface or a sturdy
outrigger support must be used if a table extension over 24'' long is attached
to the saw.
ASSEMBLING SAW BLADE
1. Remove the arbor nut by turning clockwise as shown in Fig. 7.
2. Remove the flange and place saw blade on the arbor.
3. Replace arbor flange and nut then tighten the arbor nut using a piece of
wood to block the blade as shown in Fig.8.
TABLE INSERT
The table insert (A) is placed in the opening in the saw table, as shown in
Fig.9 and should be level with the surface of the saw table. To adjust the
table insert (A), use a straight edge as shown in Fig.9 and turn the four
adjusting screws in the insert, in or out, until the insert is flush with the table.
ASSEMBLY
FIGURE 8
B
FIGURE 5
FIGURE 6
FIGURE 7
A
FIGURE 9
A