Hummer H2 2005 Getting To Know Manual page 7

• Press and hold the minute button
until the correct minute appears on
the display.
Note: The time may be set with the
ignition on or off.
Program radio station presets
• Turn the radio on.
• Press BAND to select the band (AM,
FM1/FM2).
• Use the seek or tune knob to tune in
the desired station.
• Press AUTO EQ or AUTO TONE (as
applicable to your radio) to select the
equalization that best suits the type of
station selected.
• Press and hold one of the six num-
bered buttons until a beep sounds;
release the button.
• Repeat these steps for each station
preset, using a different numbered
button for each station.
Six-Disc CD Changer (if equipped)
Load one CD
• With the ignition on, press and
release the LOAD side of the LOAD
CD button.
• Wait for the indicator light at the right
side of the slot to turn green.
• Insert the disc partway into the slot,
label side up; the player will pull the
disc in.
Eject a CD
• Press and release the eject button
( ).
Load multiple CDs
• With the ignition on, press and hold
the LOAD button for two seconds.
The unit beeps and the light to the
right of the slot begins to flash.
• When the light stops flashing and
turns green, insert a disc partway,
label side up.
• The indicator light will begin blinking
and turn steadily green. Load another
disc at this time.
• When loading more than one but
fewer than six CDs, press the LOAD
button again to signal that loading is
complete.
• When more than one disc is loaded,
a number for each disc is displayed.
• To play a specific CD, press the CD
AUX button and then the number of
the CD you want to hear.
• A small bar appears under the CD
number that is playing, and the track
number appears.
Eject multiple CDs
• Press and hold the Eject button (
for two seconds. You will hear a beep
and the light will flash when a CD is
being ejected.
See Section 3 of your Owner Manual.
7
)