Driver Information Center Steering Wheel Controls - Hummer H2 2005 Getting To Know Manual

Getting to Know Your H2
18
Driver Information Center
Steering Wheel Controls
(if equipped)
Your steering wheel-mounted DIC con-
trols offer a variety of functions, includ-
ing providing access to trip and fuel
economy information.
Odometer/Trip Settings
Your vehicle's odometer/trip settings
operate only when they are turned on.
• Press the Trip button (
the odometer setting. Continue to
press the Trip button to access the
following trip modes:
– Trip A
– Trip B
– Timer
– Engine Hours
Reset trip information
• Press and hold
while viewing any of the trip modes
on the Driver Information Center.
Note: Whether your vehicle is equipped
with a Driver Information Center or not,
you can select and reset trip features by
using the Trip Odometer Reset Stem
located on the instrument panel cluster.
) to access
for two seconds
Fuel Information
Press the Fuel Information button
to scroll through the Fuel Range, Fuel
Used, Average Economy and Engine Oil
Life selections on the Driver Information
Center.
Fuel Range
This mode shows the range in miles that
the vehicle can travel with the current
amount of fuel. The display will show
Low if the fuel level is low.
Fuel Used
This mode shows the current amount
of fuel used in gallons since the last
reset for Fuel Used. This mode should
be reset after every fuel tank fill-up.
Average Economy
This mode shows the average fuel
economy in miles per gallon since the
last reset for Average Economy.
Engine Oil Life
This mode shows the percentage of oil
life left until it is recommended to
change the engine oil. An oil and filter
change should be performed within 600
miles of the Change Oil message being
displayed.
Reset Fuel Information
• While a fuel information mode is
displayed, press and hold
for several seconds. The displayed
mode will be reset.
See Section 3 of your Owner Manual.