Table of Contents
Advertisement
Full Sequential Safety Trip
Mechanism Testing Procedure
FROM ACCIDENTAL
OPERATION: Point the tool at
a piece of scrap wood when
testing.
1.
Disconnect tool from the air supply.
2.
Put at least 10 nails in the Magazine
(The Nailer will not fire if empty or
with only a few fasteners loaded.)
3.
Check that the Trigger and the Nail
move freely and without sticking.
4.
Connect air supply to tool and set
within Operating Air Pressure range
indicated on the Specification chart.
5.
Push down and turn Trigger Lock
(35) clockwise to unlock Trigger. (See
lock/unlock symbols on housing.)
6.
Test tool by pressing the Nail against
the workpiece without pulling the Trig-
ger. The Tool must not cycle (fire).
If it cycles (fires), stop immediately
and have it repaired by a qualified
service technician.
7.
Hold tool away or off of workpiece.
The Nail should return to its original
position. Squeeze Trigger. The tool
must not cycle (fire). If tool fires,
stop immediately and have it repaired
by a qualified service technician.
8.
Press the Nail against the workpiece
and squeeze the Trigger. The tool
must cycle (fire) only once. Re-
lease the Trigger and squeeze it
again. The tool must not cycle
(fire). With the Trigger held, carefully
lift the tool and press it against the
SKU 67100
TO PREVENT
SERIOUS INJURY
For technical questions, please call 1-800-444-3353.
workpiece again. The tool must not
cycle (fire). If it fails to perform in
the manner explained in bold, have it
repaired by a qualified service techni-
cian.
Loading/Unloading Nailer
FROM ACCIDENTAL
OPERATION, BEFORE
LOADING:
• Wear ANSI-approved safety
goggles with side shields.
Other people in the work area
must also wear ANSI-approved
safety goggles with side shields.
• Release the trigger.
• Detach the air supply.
• Attempt to fire the Tool into a
piece of scrap wood to ensure
that there is no trapped air
and is incapable of firing any
fasteners.
1.
To load nails, hold Nailer with Nose
(74) pointing downward and insert
stick of metal connecting nails into
back of Magazine (85).
2.
Slide nail stick (not included) all the
way to front of Magazine.
3.
Pull Pusher (84) towards back of
Magazine and past last nail. Release
Pusher, allowing it to engage with nail
stick.
4.
To unload nails, press down on Push-
er Latch (81) to disengage Pusher
from Nails.
5.
Slowly slide Pusher past the nails
and toward Nose.
TO PREVENT
SERIOUS INJURY
Page 10
Advertisement
Table of Contents
