Care And Cleaning - Zanussi ZWH 6125 User Manual

1. Turn the programme selector dial to
2. Select the draining or spinning programme.
3. Reduce the spin speed if needed, by pressing the
relevant button.
4. Press button 7 .
At the end of the programme, the door is released and can
be opened. Turn the programme selector dial to
switch the machine off.
Remove the laundry from the drum and carefully check
that the drum is empty. If you do not intend to carry out

Care and cleaning

Warning! You must DISCONNECT the appliance
from the electricity supply, before you can carry out
any cleaning or maintenance work.
Descaling
The water we use normally contains lime. It is a good idea
to periodically use a water softening powder in the ma-
chine. Do this separately from any laundry washing, and
according to the softening powder manufacturer's in-
structions. This will help to prevent the formation of lime
deposits.
External cleaning
Clean the exterior cabinet of the appliance with soap and
water only, and then dry thoroughly.
Cleaning the drawer recess
The washing powder and additive dispenser drawer
should be cleaned regularly.
Remove the drawer by
pressing the catch down-
wards and by pulling it
out. Flush it out under a
tap, to remove any traces
of accumulated powder.
.
to
To aid cleaning, the top
part of the additive com-
partment should be re-
moved.
another wash, close the water tap. Leave the door open to
prevent the formation of mildew and unpleasant smells.
Stand By : If your laundry is not removed within 10 mi-
nutes after the programme is finished, the back light of
the display switches off and the energy saving system will
be enabled. Only the pilot light of the button 7 is blinking
to indicate that the appliance has to be switched off. By
pressing any button the appliance will come out from the
energy saving status and you can set another programme
or switch the appliance off.
Cleaning the drawer recess
Replace the drawer and run the rinse programme with-
out any clothes in the drum.
Cleaning the pump
The pump should be inspected if:
• the machine does not empty and/or spin;
• the machine makes an unusual noise during draining
due to objects such as safety pins, coins etc. blocking
the pump.
Proceed as follows:
• disconnect the appliance;
• if necessary wait until the water has cooled down.
Having removed the draw-
er, use a small brush to
clean the recess, ensuring
that all washing powder
residue is removed from
the upper and lower part of
the recess.
Open the pump door.
Place a container close to
the pump to collect any
spillage.
13