Zanussi ZWH 6120 P User Manual

Washing machine
Hide thumbs Also See for ZWH 6120 P:

Advertisement

User manual
EN
Washing Machine
ZWH 6120 P
ZWH 6140 P
ZWH 6160 P

Advertisement

Table of Contents
loading

Summary of Contents for Zanussi ZWH 6120 P

  • Page 1 User manual Washing Machine ZWH 6120 P ZWH 6140 P ZWH 6160 P...
  • Page 2: Table Of Contents

    • If the appliance has a child safety device, we recommend you ac- tivate it. General Safety • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not change the specification of this appliance. www.zanussi.com...
  • Page 3: Safety Instructions

    13 amp mains plug. If it is necessary to between the appliance and the carpet. change the fuse in the mains plug, use a 13 Electrical connection amp ASTA (BS 1362) fuse. • Warning! Risk of fire and electrical shock. www.zanussi.com...
  • Page 4: Frost Precaution

    6. let the drain hose run along the floor, place the external extremities of the drain and in- let hoses in the bowl placed on the floor and let water drain out completely; www.zanussi.com...
  • Page 5: Environment Concerns

    Packaging materials then be washed at a lower temperature. The materials marked with the symbol • Measure out detergent according to the wa- recyclable. ter hardness, the degree of soiling and the >PE<=polyethylene quantity of laundry being washed. >PS<=polystyrene www.zanussi.com...
  • Page 6: Product Description

    To disable this device and restore the possi- (without pressing it) inside the door clockwise bility of closing the door, rotate the button anti- until the groove is horizontal. If necessary use a clockwise until the groove is vertical. coin. www.zanussi.com...
  • Page 7: Technical Data

    • Spread the front piece on the floor behind the appli- ance and then lay 10 mm the appliance care- fully rear side down 30 mm on it. Make sure that no hoses are crushed in the process. www.zanussi.com...
  • Page 8 • Remove the power supply cable and the draining and inlet hose from the hose hold- ers on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. www.zanussi.com...
  • Page 9 The end of the drain hose can be positioned in four ways: Warning! This appliance is free standing • Hooked over the edge of a sink using only. Do not remove the worktop for any the plastic hose guide. reason. www.zanussi.com...
  • Page 10 • Directly into a drain pipe at a height of The drain hose may be extended to a maxi- not less than 60 cm and not more than mum of 4 metres. An additional drain hose 100 cm. and joining piece is available from your Local Centre. www.zanussi.com...
  • Page 11 • Do not pull the mains cable to disconnect DISHWASHER MACHINE the appliance. Always pull the mains plug. RAINWATER ‘RUN-OFF’ • This appliance complies with the E.E.C. Di- rectives. FOUL DRAIN SURFACE WATER FOUL SEWERS DRAINS & SEWERS SEWAGE TREATMENT UNTREATED WORKS DISCHARGE TREATED DISCHARGE RIVER RIVER www.zanussi.com...
  • Page 12: First Use

    Lipstick: moisten with acetone as above, then arately the first time. treat stains with methylated spirits. Treat any re- sidual marks with bleach. • Rub particularly soiled areas with a special detergent or detergent paste. 1) do not use acetone on artificial silk. www.zanussi.com...
  • Page 13 Water hardness is classified in so-called “de- door. grees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your lo- cal authority. www.zanussi.com...
  • Page 14 If the flap is not in the desired position: • Measure out the detergent. For the quantity of detergent, refer al- ways to what is written on the product packing and ensure that the detergent can be poured in the drawer. www.zanussi.com...
  • Page 15 When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programme Chart". If an incorrect option is selected, the integrated red pilot light of the button 6 flashes 3 times. www.zanussi.com...
  • Page 16 By pressing this button the corresponding pilot light illumi- nates. Short cycle for lightly soiled items or for laundry which needs only freshening up. With this option, a reduced load of laundry is recommended: • Cottons 3,5 kg • Synthetics and delicates 2 kg www.zanussi.com...
  • Page 17 If you need to open the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait a few minutes. After you have closed the door, press the button 6 again. www.zanussi.com...
  • Page 18 Remove the laundry from the drum and carefully Follow the below instructions to empty out the check that the drum is empty. If you do not in- water: tend to carry out another wash, close the water www.zanussi.com...
  • Page 19: Washing Programmes

    White and coloured cotton. This programme can be selec- DELAY START ted for slightly or normally soiled cotton items. The tempera- ture will decrease and the washing time will be extended. This allows to obtain a good washing efficiency by saving energy. www.zanussi.com...
  • Page 20 Select the EXTRA RINSE option to intensify the rins- DELAY START, ing action. The appliance adds additional rinses. DRAIN Draining of water For emptying out the water left in the drum in the programmes with Rinse Hold option. www.zanussi.com...
  • Page 21: Consumption Values

    «Standard 40 °C cotton programme». They are the most efficient programmes in terms of combined energy and water consumptions for washing normally soiled cotton laundry. The water temperature of the washing phase may differ from the temperature declared for the selected programme. Consumption values www.zanussi.com...
  • Page 22: Care And Cleaning

    We recommend that a maintenance wash be performed on a regular basis. To run a maintenance wash: • The drum should be empty of laundry. www.zanussi.com...
  • Page 23 • Clean all the removed parts of the dispens- open until the filter re- er drawer under a tap to remove any traces moval. of accumulated powder. • before removing the filter, remove any fluff or small objects from around the filter; www.zanussi.com...
  • Page 24: What To Do If

    Before contacting your local Service Centre, gineer. please carry out the checks listed below. www.zanussi.com...
  • Page 25 – At the end of cleaning action, close the door and insert the mains plug again; – Run a drain programme to check if the appliance works now. The light of button 6 flashes and the light 7.3 illuminates: Door open www.zanussi.com...
  • Page 26 • Wait the end of washing cycle. The door lock has not been released. The door will not open: • Wait until the door lock is released. There is water in the drum. • Select drain or spin programme to empty out the water. www.zanussi.com...
  • Page 27 We recom- appliance and press the button 6 to restart the mend that you write the data here: programme. If the malfunction shows again, contact your Service Centre. The necessary data for the www.zanussi.com...
  • Page 28 Model description (MOD.) ........Product number (PNC) ..........Serial number (S.N.) ..........Mod..Prod. No..Ser. No..www.zanussi.com...
  • Page 29 www.zanussi.com...
  • Page 30 www.zanussi.com...
  • Page 31 www.zanussi.com...
  • Page 32 www.zanussi.com/shop...

Table of Contents