• If the appliance has a child safety device, we recommend you ac- tivate it. General Safety • Before maintenance, deactivate the appliance and disconnect the mains plug from the mains socket. • Do not change the specification of this appliance. www.zanussi.com...
13 amp mains plug. If it is necessary to between the appliance and the carpet. change the fuse in the mains plug, use a 13 Electrical connection amp ASTA (BS 1362) fuse. • Warning! Risk of fire and electrical shock. www.zanussi.com...
6. let the drain hose run along the floor, place the external extremities of the drain and in- let hoses in the bowl placed on the floor and let water drain out completely; www.zanussi.com...
Packaging materials then be washed at a lower temperature. The materials marked with the symbol • Measure out detergent according to the wa- recyclable. ter hardness, the degree of soiling and the >PE<=polyethylene quantity of laundry being washed. >PS<=polystyrene www.zanussi.com...
To disable this device and restore the possi- (without pressing it) inside the door clockwise bility of closing the door, rotate the button anti- until the groove is horizontal. If necessary use a clockwise until the groove is vertical. coin. www.zanussi.com...
• Spread the front piece on the floor behind the appli- ance and then lay 10 mm the appliance care- fully rear side down 30 mm on it. Make sure that no hoses are crushed in the process. www.zanussi.com...
Page 8
• Remove the power supply cable and the draining and inlet hose from the hose hold- ers on the rear of the appliance. • Plug the smaller upper hole and the two large ones with the corresponding plastic plug caps. www.zanussi.com...
Page 9
The end of the drain hose can be positioned in four ways: Warning! This appliance is free standing • Hooked over the edge of a sink using only. Do not remove the worktop for any the plastic hose guide. reason. www.zanussi.com...
Page 10
• Directly into a drain pipe at a height of The drain hose may be extended to a maxi- not less than 60 cm and not more than mum of 4 metres. An additional drain hose 100 cm. and joining piece is available from your Local Centre. www.zanussi.com...
Page 11
• Do not pull the mains cable to disconnect DISHWASHER MACHINE the appliance. Always pull the mains plug. RAINWATER ‘RUN-OFF’ • This appliance complies with the E.E.C. Di- rectives. FOUL DRAIN SURFACE WATER FOUL SEWERS DRAINS & SEWERS SEWAGE TREATMENT UNTREATED WORKS DISCHARGE TREATED DISCHARGE RIVER RIVER www.zanussi.com...
Lipstick: moisten with acetone as above, then arately the first time. treat stains with methylated spirits. Treat any re- sidual marks with bleach. • Rub particularly soiled areas with a special detergent or detergent paste. 1) do not use acetone on artificial silk. www.zanussi.com...
Page 13
Water hardness is classified in so-called “de- door. grees” of hardness. Information on hardness of the water in your area can be obtained from the relevant water supply company, or from your lo- cal authority. www.zanussi.com...
Page 14
If the flap is not in the desired position: • Measure out the detergent. For the quantity of detergent, refer al- ways to what is written on the product packing and ensure that the detergent can be poured in the drawer. www.zanussi.com...
Page 15
When an option button is selected, the corresponding pilot light is on. Otherwise it is off. For compatibility among washing programmes and options, see the "Washing Programme Chart". If an incorrect option is selected, the integrated red pilot light of the button 6 flashes 3 times. www.zanussi.com...
Page 16
By pressing this button the corresponding pilot light illumi- nates. Short cycle for lightly soiled items or for laundry which needs only freshening up. With this option, a reduced load of laundry is recommended: • Cottons 3,5 kg • Synthetics and delicates 2 kg www.zanussi.com...
Page 17
If you need to open the door, you must set the appliance to PAUSE (by pressing the button 6) and then wait a few minutes. After you have closed the door, press the button 6 again. www.zanussi.com...
Page 18
Remove the laundry from the drum and carefully Follow the below instructions to empty out the check that the drum is empty. If you do not in- water: tend to carry out another wash, close the water www.zanussi.com...
Main wash - Rinses - Maximum spin speed at 1200 rpm RINSE HOLD Max. load 3,5 kg - Reduced load 2 kg SUPER QUICK Synthetic or mixed fabrics: underwear, coloured garments, EXTRA RINSE non-shrink shirts, blouses . Normally soiled items. DELAY START www.zanussi.com...
Page 20
In order to obtain the best anti-creasing result, reduce the RINSE HOLD load of synthetics items. (Recommended load 1 Kg) EXTRA RINSE Synthetic or mixed fabrics. Gentle wash and spin to avoid DELAY START any creasing. The appliance performs additional rinses. www.zanussi.com...
• Select the hottest cotton wash programme. ment should be re- moved. • Use a normal measure of detergent, must be a powder with biological properties. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. www.zanussi.com...
Page 23
• turn programme selector dial to position • open the filter cov- • unplug the appliance; er and insert the fil- • open the door; ter again; • turn the drum and align the filter cov- er (FILTER) with the arrow on the door seal; www.zanussi.com...
Before contacting your local Service Centre, gineer. please carry out the checks listed below. Fault code and mal- Possible cause - Solution function The light of button 6 flashes and the light 7.1 illuminates: Problem with the water supply www.zanussi.com...
Page 25
– At the end of cleaning action, close the door and insert the mains plug again; – Run a drain programme to check if the appliance works now. The light of button 6 flashes and the light 7.3 illuminates: Door open www.zanussi.com...
Page 26
• Wait the end of washing cycle. The door lock has not been released. The door will not open: • Wait until the door lock is released. There is water in the drum. • Select drain or spin programme to empty out the water. www.zanussi.com...
Page 27
We recom- appliance and press the button 6 to restart the mend that you write the data here: programme. If the malfunction shows again, contact your Service Centre. The necessary data for the www.zanussi.com...
Page 28
Model description (MOD.) ........Product number (PNC) ..........Serial number (S.N.) ..........Mod..Prod. No..Ser. No..www.zanussi.com...