Advertisement
Precautions
• To avoid electrical shock, do not open the case of this product.
• Only use a regulated DC 12V Power supply to operate this product.
• Do not overload electrical outlets or extension cords; this can result in fire or
electric shock.
• Keep this product away from strong magnetic fields.
• Do not expose this product in direct sunlight or strong reflected rays.
• Refer servicing to qualified personnel only.
• Do not change or modify this product; the warranty will be void.
Features
• 1/3" Sony Super HAD CCD
• 540 TVL
• Rugged Steel Construction
• IP66
• DC 12V
Installation
1. Loosen the two locking screws①, using the supplied hex-head wrench and remove
the mounting base.
2. Attach the mounting base② to a suitable solid surface, such as a wall or ceiling. On
partitioning locate a wall stud or ceiling joist. Secure the mounting base using the
supplied screws③. Fit the camera④ to the mounting base ② and fix in to position
using the two locking screws①, secure them with the hex-head wrench.
3. How to set the angle of view:
Loosen the two locking screws①, using the supplied hex-head wrench, and set the
desired camera angle by moving the camera right /left and up/down.
4. Connect the video connector (BNC) of the camera cable to the incoming video
cable. The other end of the video cable should be connected to a DVR or Monitor.
Plug the camera power connector (red DC jack) into the DC12V regulated power
supply. Switch on the power supply and the picture should will now be displayed on
the Monitor.
Advertisement
