Chain Saw Names And Terms - Remington M15012US Owner's Manual

CHAIN SAW NAMES AND TERMS

Process of cutting a felled tree or log
Bucking
into lengths.
Block or wedge used to secure wood from
Chock
moving.
Process of cutting down a tree.
Felling
Final cut when felling a tree. Make this
Felling Cut
cut on opposite side of tree from notching cut.
Located at front of saw body.
Front Handle
Shield between front handle
Front Hand Guard
and guide bar. Protects left hand while using
saw.
Metal bar that extends from saw body.
Guide Bar
The guide bar supports and guides chain.
Tip or end of guide bar.
Guide Bar Nose
Bolt-like fastener that holds
Guide Bar Retainer
guide bar in place during assembly and operation
of chain saw.
Quick backward and upward motion
Kickback
of guide bar. Kickback may occur when tip of
guide bar touches an object while chain is mov-
ing. The guide bar will kick up and back towards
operator.
Process of cutting limb(s) from a felled
Limbing
tree.
Chain that reduces chance of
Low-Kickback Chain
kickback as required by ANSI B175.1.
Stance used while making
Normal Cutting Position
bucking and felling cuts.
Notch cut in tree that directs fall of
Notching Cut
tree.
System for oiling guide bar and
Oiler Control
chain.
Chain saw without chain and guide
Power Head
bar. Also known as saw body.
Pushback (Kickback, Pinch)
chain saw. Pushback may occur if chain along
top of guide bar is pinched, caught, or contacts a
foreign object.
www.remingtonpowertools.com
Rear Handle
body.
Reduced Kickback Guide Bar
reduces chance of kickback.
Replacement Chain
ANSI B175.1 when used with a specific saw. It
may not meet ANSI requirements when used with
other saws.
Saw Chain (Chain)
teeth for cutting wood. The motor drives chain.
The guide bar supports chain.
Spiked Bumper (Spike)
saw body beside guide bar. Keep spiked bumper
in contact with wood when felling or bucking. It
helps maintain position of saw while cutting.
Sprocket
Switch
cal circuit to motor of saw.
Switch Linkage
to trigger. It moves switch when you squeeze
trigger.
Switch Lockout
starting of saw.
Trigger
ing trigger turns saw on. Releasing trigger turns
saw off.
Trimming (Pruning)
from a living tree.
Undercut
limb. This is done while in normal cutting position
and cutting with top of guide bar.
Unibody
Rapid pushback of
8
Handle located at rear of saw
Guide bar that
Chain that complies with
Loop of chain having cutting
Pointed teeth at front of
Toothed wheel that drives chain.
Device that completes or interrupts electri-
This device connects switch
Device that reduces accidental
Device that turns saw on and off. Squeez-
Process of cutting limb(s)
An upward cut from underside of log or
Main body of chain saw.